# How to Read X, Y and Z Coordinates in a STEP File

Use Point coordinates in CADProps to locate a STEP vertex relative to the file origin, check the units and tell position apart from size.

Open your file in the [CADProps STEP viewer](https://www.cadprops.com/tools/step-viewer/index.md), choose **Measure → Point coordinates**, and click the corner you want to locate. The saved **Point** reading gives X, Y and Z relative to the STEP file's original axes. Check the displayed units before comparing the readings with a drawing or another export.

## Try a block that starts 10 mm from the origin

1. Download the [shifted STEP block](https://www.cadprops.com/assets/evidence/seo-2026-11-15/block-shifted-x.step) and open it in the viewer. Use millimetres and turn the model until the top corners are clear.
2. Choose **Point coordinates** and select the top corner at the positive end of all three axes. That vertex is at **(50, 30, 20) mm**.
3. Read the other end of the same top edge along X. The corresponding corner is at **(10, 30, 20) mm**. Subtracting the X readings gives the block's **40 mm** length. The 10 mm offset is part of the model's placement.

<figure class="workflow-evidence"><img src="/assets/evidence/seo-2026-11-16/step-source-coordinates-1440.webp" alt="Side-view schematic showing the origin at X zero and two STEP block corners at X ten and fifty millimetres" width="1440" height="720" loading="lazy"><figcaption>Schematic of the shifted block. Both marked vertices are at Y = 30 mm and Z = 20 mm. The X readings differ by 40 mm.</figcaption></figure>

## If the point reads somewhere else

Zoom in and rotate to expose the corner, then select it again. A click near a mesh vertex can snap to that vertex. A click on the middle of a face can return a different location. Check a second known corner before using the coordinates in a handoff.

Fitting or rotating the view does not change the file axes. If the coordinates still disagree with a drawing, check whether that drawing uses a local datum or a different export origin. For a curved hole, the point tool reads the picked surface location. Use the supported [measurement modes](https://www.cadprops.com/guides/measure-step-file/index.md) when your reference is a feature center or an axis.

## Related reading

- [Which CADProps CSV Contains Your Measurements?](https://www.cadprops.com/guides/export-cad-measurements-vs-properties-csv/index.md)
- [How to Measure Thickness Between Two STEP Faces](https://www.cadprops.com/guides/measure-parallel-face-distance-step/index.md)
- [Measure STEP Files Online: Dimensions, Distances & Units](https://www.cadprops.com/guides/measure-step-file/index.md)
- [How to Measure Hole Center Distance in a STEP File](https://www.cadprops.com/guides/measure-step-hole-center-distance/index.md)
- [STEP File (.step, .stp): What It Is and How to Open It](https://www.cadprops.com/guides/step-file-what-it-is-how-to-open/index.md)

Original article: https://www.cadprops.com/guides/read-point-coordinates-step/

HTML page: https://www.cadprops.com/guides/read-point-coordinates-step/
