# How to Measure the Gap Between Coplanar STEP Faces

Use Trimmed geometry distance in CADProps to measure between the actual boundaries of two STEP faces that share a plane.

Open the STEP in the [CADProps dimensions tool](https://www.cadprops.com/tools/cad-dimensions/index.md) and choose **Measure → Distance → Trimmed geometry distance**. Click inside each of the two faces. This mode measures the shortest distance between the bounded CAD faces. It can report a positive gap when both faces lie at the same height.

## Check the gap across a recessed slot

1. Open the [two-pad STEP sample](https://www.cadprops.com/assets/evidence/seo-2026-11-20/coplanar-pads.step) and use millimetres.
2. Pick the broad top face on the left, then the broad top face on the right. Click away from their edges so the whole faces are selected.
3. Read **8 mm**, the distance between the nearest boundaries. The two tops lie at Z = 12 mm. A measurement between their extended support planes gives **0 mm** because those planes coincide.

<figure class="workflow-evidence"><img src="/assets/evidence/seo-2026-11-20/coplanar-face-gap-1440.webp" alt="Side schematic showing two STEP faces on the same plane, with an eight-millimetre gap between their bounded surfaces" width="1440" height="680" loading="lazy"><figcaption>Schematic of the sample. The faces share a plane, and their physical boundaries are 8 mm apart.</figcaption></figure>

If the viewer highlights an edge, move farther inside the face and pick again. Use two different references from the same uploaded model. If the mode is missing, check for a complete CAD B-Rep instead of a mesh preview. When you need the vertical separation of opposing planes, use [Face distance](https://www.cadprops.com/guides/measure-parallel-face-distance-step/index.md).

## Related reading

- [Which CADProps CSV Contains Your Measurements?](https://www.cadprops.com/guides/export-cad-measurements-vs-properties-csv/index.md)
- [How to Measure Thickness Between Two STEP Faces](https://www.cadprops.com/guides/measure-parallel-face-distance-step/index.md)
- [How to Measure a Countersink Angle in a STEP File](https://www.cadprops.com/guides/measure-step-countersink-angle/index.md)
- [How to Measure the Perimeter of a STEP Face With a Hole](https://www.cadprops.com/guides/measure-step-face-perimeter-with-hole/index.md)
- [Measure STEP Files Online: Dimensions, Distances & Units](https://www.cadprops.com/guides/measure-step-file/index.md)
- [How to Measure Hole Center Distance in a STEP File](https://www.cadprops.com/guides/measure-step-hole-center-distance/index.md)
- [How to Measure the Thickness Under a Pocket in a STEP File](https://www.cadprops.com/guides/measure-step-pocket-floor-thickness/index.md)
- [How to Read X, Y and Z Coordinates in a STEP File](https://www.cadprops.com/guides/read-point-coordinates-step/index.md)

Original article: https://www.cadprops.com/guides/measure-gap-between-coplanar-step-faces/

HTML page: https://www.cadprops.com/guides/measure-gap-between-coplanar-step-faces/
